wholesale PIR switch supplier&manufacturer,china oem PIR switch factory
October 13,2021
PIR Switch Factory Supplier Manufacturer
PIR switches refers to the human body infrared intelligent sensor switch, which is a switch that is automatically activated when someone passes by the infrared sensor detection area. There are many types, including human body sensor switches, human body sensor lights, microwave sensor switches, wave sensor lights, wireless remote control switches, human body sensor switch modules, high-frequency transceiver modules and home smart products.
Performance characteristics
- Due to ultra-low power consumption design, it can be connected in series in the lighting circuit of lamps and lanterns, unipolar control energy-saving lamps (fluorescent lamps). The special model can realize the product of strong emergency control.
- The starting control illuminance can be adjusted: if it is adjusted counterclockwise, the switch can be activated in a stronger environment; if it is adjusted clockwise, the switch can be activated in a weaker environment, that is, it can only be activated when it is darker.
- The delay time can be adjusted: the adjustment range is about 20 seconds to 6 minutes. If it is adjusted counterclockwise, the delay time will become shorter; if it is adjusted clockwise, the delay time will become longer.
[Performance index]:
| Working voltage: 160～250V (AC) | Static power consumption current: <0.3mA |
|---|---|
| Environmental working temperature: -20℃～50℃ | Automatic delay time: 20 seconds～6 minutes |
| Control load power: 5～200W | Induction Distance: 6 meters |
| Induction angle: 140 degree cone angle | Load range: Incandescent lamp/energy-saving lamp/exhaust fan |
| Control illuminance: 5LUX-500LUX (adjustable) | Appearance size: 86X86X25mm |
Precautions
▲ During installation, no live wiring is allowed, and load short circuit is strictly prohibited. For products that control fluorescent lamps and energy-saving lamps, it may take 30-60 seconds for the internal voltage to establish time for the switch to work normally when it is powered on for the first time.
▲ Due to the large starting current of fluorescent lamps and energy-saving lamps, it is recommended that one switch control less than two loads. If the control load is too much, you should consult the manufacturer. In addition, frequent on and off may affect the service life of energy-saving lamps, which is a normal phenomenon.
▲ Do not install the product where there is hot air flow. If the control load is a heating light source, the distance between the switch and the light source should be greater than 1m.
▲ The control of LED lights has special requirements for the product, which must be specifically stated when purchasing.
▲ 2-wire products without neutral line and emergency control do not need to consider the wiring polarity. Products with emergency control or neutral line must be wired as shown in the diagram (no emergency control product, EM terminal is not wired).
▲ When adjusting the light control illuminance and delay time knobs, be sure to use moderate force to prevent damage to the product caused by excessive force.
We are wholesale PIR switch supplier&manufacturer,china oem PIR switch factory, any interest, any problems, welcome to consult us at any time.
☎️Tel: +86 13567940672 ?Email: sales@technic-lighting.com
PIR Switch Factory Supplier Manufacturer